Search results

I have to display this because it is such a nice piece of equipment. I will be using this to make many bumpers, nerf bars and roll cages. I made the stand this weekend and bent up some 2 inch chomoly for a roll cage. It is air over hydraulic and I have 2 inch, 1.5 inch and 1 inch dies. If...

Try not to laugh, I am not a graphic designer. You get the idea. I love ragging on all my friends that have jeeps. I want to see if there is some interest out there before I commit to getting a buch of these made. I would get them as 3inch by 11.5 which is a pretty standard bumper sticker.

I was flexing out my Ex in this V notch, my tires were at about 11 psi, the pics tell the rest of the story.

Ok, here it is. Alot of this stuff is listed in my SAS registry and other threads, but I wanted to condense all my mods here. It started as a 1994 Explorer Sport, here is a list of mods. Front Axle 78 Bronco Dana 44 High Pinion Warn Hubs 4.88:1 Gearing Lock Right Custom wristed and...

Here is the exhaust I just installed on my 94 sport. This is a great, cheap way to do it for better sound. First I removed both cats, then I cut the rear one off of the the front one. Next I beat out the catalyst in the front cat. I needed to retain the flange that attaches to the exhaust...

Ok it's finally looking like something. This thing should be complete by the end of next week, so I am posting this in the registry instead of the projects section, I hope that's OK with everyone. Front:Full width Dana 44 from a 78 Bronc with 4.88s and a Lock Rite Wild horses coils, custom...

Hey Players, Check out my new custom fab bumper. It is 2 inch .180 wall-the good stuff!! This week I am going to finish the 2 inch reciever that will go between the 2 center tubes. The whole thing is bolt on except for the side supports. I wanted to get this on before I do the SAS over...