Search results

I know they're M12x1.75, looks like 45mm long, maybe 50mm. The flange head is smaller than a typical M12 hex flange bolt, I opted to buy new ones from Ford. Cost me $8 CDN each.

Hi everyone. Finally I'm able to contribute back to this forum after coming to it for so much information. I've seen a few threads of this forum and others about people with these KOEO codes and the behaviour I'm about to describe. I couldn't however find anybody who posted a follow up to what...

Thanks for the tips! I gave it one last shot with a brand new hardened socket and managed to get it out. I heated the ear for about 10 minutes, with propane, then hit with with penetrating oil for good measure and went to work. I thought I had fully rounded the bolt head when I tried loosening...

Sorry about not clarify what bolts I was talking about, you're right, the ones that thread into the manifold from the oval shaped flange. I'm thinking it's worth calling around. I don't regularly insure this vehicle and getting a day permit here adds on another $40ish dollars which sucks. I...

I've been using 6 point sockets with a 20" extension and 24" breaker bar. I got the outermost on the passenger side the day after my original post, it was a struggle all the way out. Head is really rounding off on the innermost passenger side, last of the 4 bolts. I noticed my socket was...

I have one buddy who, I believe, might have one. I was always hoping to cash in a favour and have him help out with this but he's out of town during the COVID-19 pandemic. When you say heat it that's the manifold not the bolt, right? If I put a few pieces back together and drove it to a shop...

Hi all, I've been reading a lot of threads here and found some good info about getting the stuck bolts out but I'm wondering if anybody could provide me some input on my situation. I'm doing this on a 1993 4dr 4wd XL. The ultimate goal is to get the transmission out for a slave cylinder...

Hey, So my explorer has power seats that must have been installed by someone a while ago, and look very hastily put together. Currently, the connector isn't getting any power. They don't look like they were properly done, based off of the gauge of the wires used. Not sure what it is exactly...