Search results

Had the fuse blow about 2 years ago on my 1994 explorer and replaced it no problem since although I think it may blown one other time on start up. It happened again only this time it used about 6 fuses before starting and after being towed again. I have done a lot of searching and reading on...

My 05 explorer has been hesitating going into reverse when warmed up. Not all the time but it slams in when it finally does go in gear. It has 65,000 miles on it. I have read about the tsb on the o5 trans. Customer satisfaction program 04b22. 5r55s/e & 5r44e transmission. Has anyone had this...

When installing the locking hubs back btw I forgot to mark them do they fit solid against the hub or not. I know they will install flat against he hub or I can leave about 1/4 inch gap and they will tighten up with lugs being torqued. Just not sure mine are not working anyway,Also with all...

Had a small miss in my 94 ex so I decided to install autolite double platinum. Checked the gap on the new plugs which were around 45 so I set to 54, It is missing alot worse than before . i am pulling these autolites out today and putting the old ones back in. Are the autolites supposed to be...

Mine stopped working. Does anyone have any idea how they actually lock . I have tried ever way I can to get them locked including all the troubleshooting.They try but do not lock. Should the auto hub fit completely flat against hub before wheel goes on ?

When I turn the driveshaft to check hub engagement driveshaft turns the wheels spindle a few turns then the spindle stops turning although I keep turning driveshaft with my hand.I did jack it up all four wheels off ground push 4 high light comes on no front driveshaft movement. Then I put in...

I have 4x4 low but not high. I cannot hear any engagement when first putting into high although light comes on front wheels do not turn. When I change to low I hear engagement of gears and it works fine. Would this have to do with the shift motor or something else. Thanks

Driving on interstate last night 65 mph in my 1994 explorer engine just shut off no warning. Got to the side of highway checked the inertia switch button it was fine switched fuel pump relay no help. I know the fuel pump is not coming on cannot hear it anyway. I left it overnight 50 miles from...

Engine will not idle when cold after a few minutes it is driveable then its ok. Cleaned IAC set tps. Had new upper and lower intake gaskets installed a few years back dont think thats it. Seems to gradually get worse. Could the ECT cause this bad of an idle. I notice now my heat gauge stays on...

Transmission re built 25,000 miles ago. It never seemed to have enough pressure going into any forward gears but plenty in reverse and reverse is still fine. But now it is hard to get going into drive unless rpm's are high then it does just fine, Would the forward clutches be ok if it does not...

1994 A4LD slow going into drive but after reving to 2500 rpm transmission changes great.Re built about 25000 miles ago always seems to have low pressure in forward gears reverse fine. I can apply parking brakes while in drive unhook modulator valve at tree and transmission goes into gear fine...

I need to see pics of heater control valve installed with correct routing of heater hoses into valve and into heater core. I somehow still think mine are wrong from other pics I 've seen. THANKS

Driving in the snow the other night firtst I have used the 4 wheel drive in a while.Driving in about 4 inches of snow going real well but I noticed a loud clunk from the front end ever so often a minute or so even when sitting still.It never does it any other time that I have noticed. Any ideas...