Search results

im making lower long arms for a jeep d30 to sas my truck and ive got some 2" square tube and some bushing ends i cut from some stock ex leaf springs. my question is if i weld the bushing ends on the tube what should i do with the open part of it? or is it ok leave it like that, i got 4 of the...

i have a 94 ex with a 91 ex tranny and i used the clutch from the 91 but whats the difference between the 91 and 94 clutch? i looked on rockauto and they are both say XLT; Disc Spec: 10" OD X 1" ID X 23T, Flywheel Spec: Flat but the 94 is like 3 dollars more and is one brand better than the other?

i have james duff springs and drop brackets i was told for a 3.5" lift for a ranger and extended radius arms and i want it to droop 4-5" more what can i do heres a pic flexed as far as it goes

when i did my auto to manual swap i accidently left it in 4wd before i pulled the auto out and now its acting like its still in 4wd(both lights are lit) and the donor the tcase is in 2wd is there a way to reset the computer? i tried the white button on the 4wd computer and i had the battery...

does anyone see a problem with this coil spacer i made heres a couple pics on drivers side is 4 washers(to make up for sag) 1/4 thick and pass is 3 they gave about 2" oh and they cost me 10 bucks

when i got done putting my motor back together i found this wheres it go?

im doing a swap from a 91 ex with 5speed into my 94ex auto i got the pedals in and master cylinder but what do i do with the wiring to the clutch pedal or what does it do? also i already got the tranny harness swapped just need to get a slave cylinder then i can throw the tranny under it. can i...

is there a way to measure how much lift i have? i put a used duff lift in front i was told its 3.5" and rear i put the top 2 leafs from a blazer heres a pic how it sits now with stock size tires i want to end up with a 4" lift but i have to counter the driver side sag

i got a used 3.5" james duff lift off a buddy for 50 bucks how much lift could i have with these drop brackets and still be able to align it? i want to do soa in the rear so ill need 2" roughly in the front still

ok driver side looks good the passenger side looks like something is broken or bent and its hitting the frame and i can wiggle it with my hand ill let the pics do the rest of the talking driver passenger

ive been working on a rear bumper and im not sure if my welds are going to be strong enough let me know what you think and this is what im using with 7018 rods set at 115 amp