Search results

I had one of my LED light bulbs burn out after many many years of use. I was just wandering what everyone is using today? It's for a 2001 sport trac and I just installed new headlight assemblies. So what do you guys recommend?

Just saw that my front splash guards that have been on there for a decade are cracked and broken. I want to replace both front and rear so they will match but dam these things are hard to find plus what I have seen is expensive for a piece of plastic. Any ideas or suggestions is appreciated...

I need to replace a cracked front turn signal light assembly (the yellow one) on my 2001 Ford explorer sport trac so I might as well replace the headlight assemblies too. So what do you guys suggest for that package? Brand, style, etc. Thanks

I'm needing recommendations on some front brake pads for my 2001 sport trac. I'm tired of all the dust from what I'm running now! Also since the rotors were replaced when I added the current pads do they need anything done to them when I replace the pads? Sand paper them to remove the finish...

Okay I have owned my 2001 Ford explorer sport trac 4x4 since new (September 2001) and always gotten 15 to 16 mpg combined fuel mileage with highway speeds no more than 62mph. Once on the highway years ago doing 55mph for the 200 mile trip I pushed out 20mpg. Now the good old girl has 214,000...

Read somewhere on here about the EGR valve using a oring gasket. So does my 2001 ST 4.0 V6 engine EGR valve have a gasket that should of have been replaced by now with 207,000 miles on my engine? Thanks

2001 Ford explorer sport trac 4.0 V6 207,000 miles on engine all hoses have been replaced recently and has the aluminum thermostat housing which I just replaced the orings on the two sensors which were seeping a little. Got a cooling system pressure kit from autozone pressurized system to 16...

2001 explorer st 4 wheel drive my question is I greased the front joint on this shaft but how or can you grease the end that connects the shaft to the transfer case? I was told you can and bought the fitting that connects to the end of a grease gun reminds me of a fitting you use to air up a...

I need some sway bar end links for the rear of my 2001 sport trac. Have had the Moog kits in for over two years now but one now has started to blow out. Need something better material checked with energy suspension but nothing specific available. Any ideas about something in thermoplastic?