- Joined
- November 29, 2000
- Messages
- 10,167
- Reaction score
- 4,160
- Location
- USA
- City, State
- San Diego, PRofK
- Year, Model & Trim Level
- 1994 XLT
I have two wheel adaptors that fit snugly onto the rear axle flanges of the 1991 to 1999 Explorers. They adapt the Explorer wheel lug pattern to the 5x5.5 pattern common with solid axle swaps. They are .98" wide, 70.1MM ID to fit snugly on the hubs, and 107.9MM OD to fit snugly onto a aftermarket wheel with a 108MM ID center. They were custom made by Motorsport-tech.com approximately seven years ago. They come with 10 low profile lug nuts and installation requires you trim the ends of your axle studs. They cost about $150 new so I am selling them for $75.00 shipped. I will clean them up before shipping, pics were taken soon after they were removed from my Explorer.
