wirewrapper
New Member
- Joined
- April 10, 2012
- Messages
- 4
- Reaction score
- 0
- City, State
- waynesboro VA
- Year, Model & Trim Level
- 1996 ford explorer xlt
hello, 100% new to the forums (and to owning a ford) My 1996 Explorer XLT wont pass inspection due to the third break light being out, so I started searching, found that it may be the ballast, found one at a junkyard for 75 bucks but before i picked it up i wanted to make sure there wasnt another issue, so i checked all fuses (least the ones i could find) they are all fine, then had a friend check and make sure power was going to the ballast, nothing with or without vehicle turned on and break pressed down.
are there any other things i should check? I have well to be honest less than basic skills when it comes to working on vehicles so the only thing i could think of is attempting to trace the wires and make sure everything is connected (that is if i can find where they all run through)
Thanks
are there any other things i should check? I have well to be honest less than basic skills when it comes to working on vehicles so the only thing i could think of is attempting to trace the wires and make sure everything is connected (that is if i can find where they all run through)
Thanks